<nav id="yxily"></nav><em id="yxily"><acronym id="yxily"><input id="yxily"></input></acronym></em>

    <em id="yxily"><object id="yxily"><input id="yxily"></input></object></em>

      <rp id="yxily"></rp>
      <rp id="yxily"></rp>

      <rp id="yxily"><ruby id="yxily"></ruby></rp>
      <th id="yxily"></th>

      light tester system

      日期:2021-08-07 13:51
      瀏覽次數:2772
      摘要:
                  light tester system
      (8)Standards  
        Watt Wr fr  
        11W 10.8±1.3 W 56.1±4 KHz  
        14W 13.5±1.4 W 56.9±4 KHz  
        19W 18.9±2.2 W 53.5±4 KHz  
        22W 17.6±2.0 W 46.6±4 KHz  
         
      Inspection Method:  
         
      1.Connect Check wire(CH3,CH4/CH5,CH6) to pin (P3,P4/P5,P6) connected. [Load Resistor: 600 ohm]
         ( 300ohm resistor*2 [300Ω30W Cement resistor] series connection. )  
         
      2.Connect Check wire(CH1,CH2)with power source of AC220V/50Hz to Lands or Wire (F1,P2).   
         
      3.Measure DATA (Wr/fr) after 2 seconds from turn on.  
         
      4.Turn off AC220V/50Hz, then Switch off the Load Resistor.   
         
         
      <<Caution>>  
      (1) You should not to pull strongly when Wr/fr is measured.  
         
      (2)Since a measuring method is different compared with other types, Pls Be careful.

       

      test volt, WR,FR

      粵公網安備 44030602001522號

      ,亚洲日本一区二区三区在线,国产精品女A片爽爽免费视频,精品国产免费人成电影在线观看